Surge Protector with built in CCTV balun

Passive Video Balun and Multi Function Surge Protector

Model Number: CAMTRV24

  • Passive UTP Video Balun Transceiver
  • Multi-Function Surge Protectors for UTP Video, 2 wire control & camera supply
  • Operates with Nitek Passive or Active Receiver Baluns
  • Three Independent Multi-Stage Design Surge Protector Circuits
  • The CAMTRV24 is a single channel video balun transceiver used for UTP video transmission combined with a multi-function surge protector for in-line video, 2 wire P/T/Z control and the camera supply voltage. The CAMTRV24 provides multi-stage surge protection to a single camera system and P/T/Z unit for each of these functions. The video balun transceiver is a video transmission device that provides a low cost means of sending live video over unshielded twisted pair, point-to-point wiring for distances of up to 750 feet (225 meters). A basic system uses (2) CAMTRV24 units, one at each end of a twisted pair of wires. These units are intended for use over existing in-house telephone wiring, or category cabling or other twisted pair cable runs to provide a convenient, cost-effective alternative to coax. The CAMTRV24's are designed to provide superior immunity from noise and interference even when running next to line power! The unit can be used at the camera or head-end. The CAMTRV24 is ideally suited for outdoor cameras, where extreme protection on all signal connections is required. The unit is equipped with a BNC connector and screw terminals for the video connections and screw terminal inputs and outputs for connection to the P/T/Z data and 12/24 VAC/DC voltage connections. The CAMTRV24 provides a heavy, single point ground connection and is easily installed in minutes.

    • Built-in Nitek video balun
    • Unique multi-stage design
    • Insertion loss < 0.2 dB
    • 2.8V clamping voltage
    • Multi-function - protects video, data & camera power inputs
    • Heavy single point ground
    • Easy to install
    • Lifetime warranty
     Transceiver Unit
    Size 1.7"H x 4.3"W x 2.5"D
    Power Requirements None required
    Connection Method
    Video - BNC & Screw Terminals
    Power - Screw terminals
    Control - Screw terminals
    Clamping Voltage Video - 2.8V
    Power - 33Vrms
    Control - 4.7V
    Video Insertion Loss <0.2dB
    Impedance 50 or 75 ohms
    Temperature -40C to +85C
    Frequency DC to 10 MHz
    Shipping Weight 1 lb

    Select a type of online documentation:


    Title
     
     
     
    DOC
    CAMTRV24 Specification Sheet
     
     
     
    CAMTRV24 Installation Manual
     
     
     
    CAMTRV24 Visio Drawing
     
     
     
    CAMTRV24 Autocad Drawing