Nitek IP Camera and Power Surge Protector Solution

IP Camera Surge Protector

w/Separate 12-24V Protection Circuit

Model Number: IPPWR1

  • Single Channel Multi-Stage
  • Protects Camera Data and PoE circuits
  • Protects Low Voltage (12-24V) Power separately
  • RJ45 jacks connect input and output
  • Push-in terminals connect low voltage
  • Heavy single point ground
  • Lifetime Warranty
  • Made in the U.S.A. Tech and Design support available at 800-528-4343

    The IPPWR1 is a single channel, in-line, IP camera and PoE power surge protector for one 10/100/1000 ethernet port. In addition to the network protection the IPPWR1 provides independent protection for 12 or 24 volt power which can be used with heaters, blowers or PTZ. The unit has standard RJ45 jacks for easy connection and push-pin connectors for the low voltage channel. The IPPWR1 is ideal for small or restricted spaces. The Unit provides a heavy duty, single point ground connection and is easy to install in minutes. The IPPWR1 is recommended for use with the Etherstretch™ family of products, where surge protection is a required.The IPPWR1 is covered by a limited Lifetime Warranty.

    • Insertion loss < 0.2 dB
    • Heavy single point ground
    • Easy to install
    • Lifetime warranty
    • Separate power protection for 12 or 24VDC/VAC

     Surge Protector Unit
    Size 0.9" H x 2.5" W x 1.8" D
    Power Requirements None required
    Network Connection Method
    RJ45 jack connectors
    Power Connection Method
    Push-in terminals - rated to 8 amps
    Video Insertion Loss <0.2dB
    Impedance 50 or 75 ohms
    Temperature -40C to +85C
    Frequency DC to 10 MHz
    Shipping Weight 1 lb

    Select a type of online documentation:


    Title
     
     
     
    DOC
    IPPWR1 Specification Sheet
     
     
     
    IPPWR1 Installation Manual
     
     
     
    IPPWR1 Visio Drawing
     
     
     
    IPPWR1 Autocad Drawing