Nitek IP Network Extender w/4 Port PoE Switch Solution VH448UTP

Long Range 4 Port Ethernet Extender

With PoE Inserter:

Model Number: VR448UTP

  • IP Network 4 Port Extender transmits over Category Cable up to 1 mile (1,600 meters)
  • Includes Transmitter and Receiver units
  • Transmitter provides PoE power for its connected devices.
  • Transparent to the Network, no setup required
  • The VR448UTP IP Network Extender integrates a 4 port PoE network switch with our already popular Ethernet extenders. The VR448UTP ethernet extender allows IP Ethernet transmission of network data to communicate over an existing UTP or phone cable for distances up to 1 mile (1,600 meters).

    The VR448UTP IP Network Extender consists of a transmitter and receiver set which requires very little installation time and absolutely no set up or configuration. Installation requires simply connecting the wire pairs at each end of the existing UTP cable to the transmitter and receiver of the VR448UTP. Once powered up the network switch transmitter will begin producing PoE for its connected devices that require power. The receiver instantly connects to the transmitter and begins operating as a full-duplex 100BaseT Ethernet conduit. The VR448UTP is completely transparent to the network; it has no IP or MAC addresses and does not require any additional setup or programming. Connect your network devices by plugging their RJ45 connectors into the network ports of the transmitter and receiver. LEDs on the devices indicate the presence of power, transmission link and network signals for easy troubleshooting.

    The VR448UTP can operate as an IP Camera Network Extender to extend network communications and overcome cable distance limitations offering connections to devices in locations traditional networking does not allow. The VR448UTP will auto-negotiate bandwidth to compensate for wire attenuation and losses that occur from wire length, signal noise and interference. (Please refer to cable distance and bandwidth charts for further review).

    The units are constructed of industrial grade RoHS compliant plated steel which is finished with a heat resistant powder coat paint making them very durable. They are designed to mount within the camera housing, in an equipment enclosure or simply wall mount the unit using the included mounting kit. For installation of several units the RK124 rack mount kit allows for centralized power of the receiver units while maintaining an orderly installation.

    • Transmits high speed Ethernet over legacy UTP or Phone cable
    • Transmits distances up to 1 Mile (1,600 meters)
    • Integrated 4 port PoE unmanaged network switch
    • Provides PoE on demand for up to four devices
    • Supports mega-pixel cameras
    • Supports multi-camera installations
    • Fully transparent to the network
    • Supports any network device, including IP cameras
    • Dual stage surge protection.
    • Easy to install, no set up required
    • No MAC or IP addressing required
    • LED indicators for network signals, link status and power
    • Rack-mount kit available head-end
     Transceiver Unit
    Network Connections (4) RJ45 Connectors
    Wire Pair Connection RJ45/RJ11 Connector
    Power 48 Volt Class 2 Power Supply
    Network Rate 10/100 Ethernet

    Select a type of online documentation:


    Title
     
     
     
    DOC
    VR448UTP Specification Sheet
     
     
     
    VR448UTP Installation Manual
     
     
     
    VR448UTP A&E Specification
     
     
     
    VR448UTP A&E Specification
     
     
     
    VR448UTP Visio Drawing
     
     
     
    VR448UTP Autocad Drawing