Nitek Network Extender w/4 Port PoE Switch Solution VH448COAX

Long Range 4 Port Ethernet Over Coax Extender

With PoE Inserter:

Model VR448COAX

  • IP Network 4 Port Extender transmits over coax up to 2,500 ft (750 meters)
  • Includes Transmitter and Receiver units
  • Transmitter provides PoE power for its connected devices.
  • Transparent to the Network, no setup required
  • The VR448COAX IP Camera Extender over Coaxial Cable integrates a 4 port PoE network switch with our already popular Ethernet extenders. The VR448COAX ethernet extender allows IP Ethernet transmission of IP Cameras and other network devices for communication over an existing coaxial cable for distances up to 2,500 feet (750 meters).

    The VR448COAX IP Network Extender consists of a transmitter and receiver set which requires very little installation time and absolutely no set up or configuration. Installation requires simply connecting the BNC connectors at each end of the existing coaxial cable to the transmitter and receiver of the VR448COAX. Once powered up the network switch transmitter will begin producing PoE for its connected devices that require power. The receiver instantly connects to the transmitter and begins operating as a full-duplex 100BaseT Ethernet conduit. The VR448COAX Ethernet Extender is completely transparent to the network; it has no IP or MAC addresses and does not require any additional setup or programming. Connect your network devices by plugging their RJ45 connectors into the network ports of the transmitter and receiver. LEDs on the devices indicate the presence of power, transmission link and network signals for easy troubleshooting.

    The VR448COAX extends network communications to overcome cable distance limitations offering connections to devices in locations traditional networking does not allow. The VR448COAX will auto-negotiate bandwidth to compensate for wire attenuation and losses that occur from wire length, signal noise and interference. (Please refer to cable distance and bandwidth charts for further review).

    The units are constructed of industrial grade RoHS compliant plated steel which is finished with a heat resistant powder coat paint making them very durable. They are designed to mount within the camera housing, in an equipment enclosure or simply wall mount the unit using the included mounting kit. For installation of several units the RK124 rack mount kit allows for centralized power of the receiver units while maintaining an orderly installation.

    • Transmits high speed Ethernet over legacy coaxial cable
    • Transmits distances up to 2500 feet (750 meters)
    • Integrated 4 port PoE unmanaged network switch
    • Provides PoE on demand for up to four devices
    • Supports mega-pixel cameras
    • Supports multi-camera installations
    • Fully transparent to the network
    • Supports any network device, including IP cameras
    • Dual stage surge protection
    • Easy to install, no set up required
    • No MAC or IP addressing required
    • LED indicators for network signals, link status and power
    • Rack-mount kit available head-end
     Transceiver Unit
    Network Connections (4) RJ45 Connectors
    Coaxial Connection BNC Connector
    Power 48 Volt Class 2 Power Supply
    Network Rate 10/100 Ethernet

    Select a type of online documentation:


    Title
     
     
     
    DOC
    VR448COAX Specification Sheet
     
     
     
    VR448COAX Installation Manual
     
     
     
    VR448COAX A&E Specification
     
     
     
    VR448COAX A&E Specification
     
     
     
    VR448COAX Visio Drawing
     
     
     
    VR448COAX Autocad Drawing