Nitek Ethernet Extender-PoE Inserter Solution

IP Video Network Extender

with PoE Injector:

Model VR148UTP

  • Long Range IP Extender transmits over category cable up to 1 Mile (1600 meters)
  • Includes Transmitter and Receiver units
  • Transmitter converts 24vac to PoE to power network devices
  • Transparent to the Network, no setup required
  • The VR148UTP Long Range IP Video Network Extender-PoE Inserter allows IP Ethernet transmission of network data over UTP cable for distances up to 1 mile (1,600 meters). In addition, the transmitter will convert the 24VAC used to power standard analog cameras to PoE for the installation of the new IP cameras.

    The VR148UTP Long Range IP Video Network Extender-PoE Inserter consists of a transmitter and receiver set which requires very little installation time and absolutely no set up or configuration. Installation requires simply connecting the wire pairs at each end of the existing UTP cable to the transmitter and receiver of the VR148UTP. Once powered up the transmitter will produce PoE for its connected device. The receiver instantly connects to the transmitter and begins operating as a full-duplex 100BaseT Ethernet conduit. The VR148UTP is completely transparent to the network; it has no IP or MAC addresses and does not require any additional setup or programming. Connect your network devices by plugging their RJ45 connectors into the network port of the transmitter and receiver. LEDs on the devices indicate the presence of power, transmission link and network signals for easy troubleshooting.

    The VR148UTP IP Video Network Extender extends network communications to overcome cable distance limitations offering connections to devices in locations traditional networking does not allow. The VR148UTP will auto-negotiate bandwidth to compensate for wire attenuation and losses that occur from wire length, signal noise and interference. (Please refer to cable distance and bandwidth charts for further review).

    The units are constructed of industrial grade RoHS compliant plated steel which is finished with a heat resistant powder coat paint making them very durable. They are designed to mount within the camera housing, in an equipment enclosure or simply wall mount the unit using the included mounting kit. For installation of several units the RK124 rack mount kit allows for centralized power of the receiver units while maintaining an orderly installation.

    • Transmits high speed Ethernet over legacy UTP or Phone cable
    • Transmits distances up to 1 Mile (1,600 meters)
    • Transmitter converts 24vac to PoE for network devices
    • Supports mega-pixel cameras
    • Supports multi-camera installations
    • Fully tranparent to the network
    • Supports any network device, including IP cameras
    • Dual stage surge protection
    • Easy to install, no set up required
    • No MAC or IP addressing required
    • LED indicators for network signals, link status and power
    • Rack-mount kit available head-end
     Transceiver Unit
    Network Connection RJ45 Connector
    Twisted Pair Connection RJ11 Connector
    Power 24VAC @ 1amp
    Network Rate 10/100 Ethernet

    Select a type of online documentation:


    Title
     
     
     
    DOC
    VR148UTP Specification Sheet
     
     
     
    VR148UTP Installation Manual
     
     
     
    VR148UTP A&E Specification
     
     
     
    VR148UTP A&E Specification
     
     
     
    VR148UTP Visio Drawing
     
     
     
    VR148UTP Autocad Drawing