Dual Channel Stand Alone CCTV Video & Data Fiber Optic Receiver

Model Number: FRS324104S00

Dual Channel Stand Alone Video & Fiber Optic Data Receiver

Nitek's FRS324104S00 is a two channel video and data, Universal-Mode™ receiver. The system requires a single fiber per channel. Both video and data are transmitted over the same fiber channel. Nitek's unique Universal-Mode™ optics allow the unit to be used with single-mode or multi-mode fiber optic cabling types.

The 3000 Series fiber optic transmission systems are designed to provide point-to-point, broadcast quality video transmission at an affordable cost, without compromise. The video is transmitted in a real time full bandwidth digital format. This insures the highest quality regardless of distance. By transmitting the video in an uncompressed format, there is no latency or loss of video quality.

An Automatic Gain control feature built into the 3000 Series compatible receivers makes this a ‟plug-and-play” video system, requiring no field setup or adjustments. The receivers are equipped with LED indicators which provide an at-a-glance operating and optics state. The 3000 Series 10 bit digital technology combined with ease of installation and inherent reliability have made this the system of choice for many critical applications.

  • Real time 10 Bit digital video eliminates signal degradation associated with distance.
  • Automatic Gain control minimizes setup and adjustment time.
  • Switchable P/T/Z data interface allows interfacing with a wide range of manufacturers protocols.
  • Universal-ModeT allows the same unit to be used with multi-mode or single-mode fiber without any set up.
  • Wide dynamic range. Provides ‟broadcast quality” video transmission.
  • Directly supports all NTSC, PAL or SECAM video formats.
  • Compatible 3000 Series Receivers are equipped with front panel LED status indicators to provide at-a-glance diagnostics of the systems video and optics state.
  • Broad operating temperature range for use in protected outdoor applications.
 System Design
Not Available in 3000 Series See 5000 Series
Optical Accepts both multi- and single-mode fiber
Multi-mode 50/125 or 62.5/125
Single-mode 9/125
Wavelength 1310nm
Optical Connector SC-PC
Path Loss 20dB min.
Operating Temperature -40 to 165 Fahrenheit
Operating Humidity 0 to 95% non-condensing
Power Requirements +12VDC to +24VDC ac/dc
Height 4.330
Width 1.375
Depth 6.770
Compression None, Uncompressed
Input / Output Level 1V p/p nominal
Input / Output Impedance 75 Ohm Unbalanced
Frequency Response 10Hz to 5.75Mhz
Differential Gain 1%
Differential Phase 1
Signal to Noise Ratio 67dB minimum
Fiber Connector SC-PC
Video Connection BNC
Video Standard NTSC/PAL
Data interface RS232, RS422 (full duplex, two wire)
  RS485 (half duplex, two wire)
Slide switch selectable Yes
Data rate per channel Up to 512kb/s
 Auxiliary Communication
Bi-directional contact closure/alarms
Alarm in Contact/relay in
Alarm out 100V / 150mA max.
Not Available in 3000 Series See 5000 Series

Select a type of online documentation:

FRS324104S00 Specification Sheet
FRS324104S00 Installation Manual
FRS324104S00 Visio Drawing
FRS324104S00 Autocad Drawing